Hi Team,
I had been sending multiple requests to add ZOTAC GAMING GeForce RTX 3080 AMP Holo to the list but not even a single GPU from Zotac had been added.
Why is this discrimination for Zotac GPU alone?
Do you have any ETA on when you might add them?
Awaiting your response.
Hello, @AravindRaja
Zotacs are not supported due to lack of software/direct control of the leds, they can only do built-in effects
There is Forestorm spectra RGB tool can you add support for something like that in signal RGB?
Is it possible to control atleast the default effects for the Zotac RTX 3080 AMP Holo GPU from signal RGB
Zotac cards don’t support direct control for the LEDs; they can only run built-in effects. This is a Zotac firmware limitation, and there’s nothing we can do about it. If Zotac launches an update for the firmware that allows us to control without saving to the device memory flash, we will add support for them.
It is somehow possible to use only those built in effects via signal rgb instead of firestom specta.
I am not a programer I know this might be hard if there is such an option to hvae atleast only the limited rgb effects to be controller via signal rgb or have an option to embed zotac firestorm spectra into signal rgb like a plug in or sometning that would be great
There is no possible way to “integrate” it. Signal’s method of control is direct writing to the device over and over. To do the same method signal does, it would burn out the onboard memory on the GPU eventually or the controller for the RGB