I have five ARGB fans of 24 LEDs each (Cooler Master HALO) connected to a single channel, so for a total of 120 LEDs. I can’t control the fans individually, but they are all synchronized as if it were a single fan. Is it possible to control each fan individually?
The same problem also occurs for the other channel with a fan and pump.
I am not sure. However, from what I have been able to figure out, it is not possible unfortunately. I personally have not seen any software that can control fan individually.
There are some that allow a little more control over the individual LEDs on the fans in that you can set each LED on the fan to a color of your choosing (for example, if you have 5 LEDs on each fan, you can have 5 different colors set on all of your fans). They are still synchronized but you would have a little more control of the colors so even though, say you have 5 fans, would technically have 25 LEDs (5 on each fan) you would still only be able to control 5 LEDs. Hope that makes sense.
I personally would love to see something like what you are talking about though where you can control each fan’s LEDs individually. That would make for some really cool effects in my opinion.
Hi, I have just finished most of my new build, no cpu or gpu yet (roll on payday), have all of my fans & rgb strips working individually, you need to purchase an internal rgb controller such as the 6 channel Razor or as in my case the 16 channel Nollie 16.
SignalRGB will then allow you to control each fan as an individual device.
