SignalRGB force close during shut down

Hello everyone,

is there any feedback on the problem that SignalRGb hangs every time it shuts down and has to be force closed?

The problem occurred sometime in January and has been mentioned here in the forum a few times, but I could not find a concrete solution or measures against it.


No news on this problem. I have uninstalled the program several times and also tested older versions. Unfortunately, this problem is permanent.
The only possibility is to quit the program before shutting down. An extra step, so to speak…

This is a normal behavior, this occurs because the software has to end all hardware connections safely. If SignalRGB don’t do this, the device may freeze or enter a soft-lock state where it would need USB replug to work again