Hi everyone i just built this computer and decided i wanted to go with the Lian Li SL infinity fans. I went with 2 triple packs of the Reverse blades. 1 triple pack and 2 single fans of regular. If that matters. I have them all connected to a Airgoo 16 channel controller. My issue is when i am trying to configure them properly in the layout it seems only half the fan shows leds. picture show below. So no matter which way i angle it in the layout editor it is still always incorrect when the getting illuminated.
This is not incorrect.
The SL Infinity LEDs mirror each other on the sides. You can verify this by clicking the component in your component configuration and using the paint tool.
Thank you so much for the reply. I figured i am doing something wrong. Do you know how I can get it to line up so no matter which way light hits it gets lit up correctly. When i have an effect hit it like the one you see i the picture both the bottom and top light up at the same time instead of the top then center then bottom if that makes sense. Again thank you very much for taking the time to answer him question and for any help you provide.
yeah that is what i meant by the sides copying, the infinity mirrors. They mirror each other, hard wired that way. So controlling 1 led will control both an led in that top and bottom in your example.