Hi, as stated my new oled monitor pops gets detected in signal rgb as ultragear 27gn950.
Im also guessing since it gets detected even though incorrectly, it can probably be made to work with signal pretty easily.
So just means LG is using the same device ID for those models, not necessarily means it can be supported, if you grab us a USB Capture, we can check what can be done.
USB capture should be:
1- Install wireshark and the usbpcap module
2- Start capturing your usb
3- Open the original software
4- Select the mode to change the device zones to a single color and the colors we want is Red: #FF0000, Green: #00FF00, Blue: #0000FF and Light Blue: #2FACED
5- Optionally set a single zone or key to one of those colors while the rest is black
6- Close the original software
7- Stop the capture on Wireshark and save the capture
8- Send the capture file here