There’s 2 LEDs on the F360 on 1 fan that wont respond properly to SignalRGB. Sometimes they wont even turn on at all, and if they stay off i would have to open up NZXT CAM to allow the 2 fan LEDs to light up again, but after opening CAM and shutting it down it no longer shows the correct colour.
As seen here i have set the color to all red via signal rgb but these 2 LEDS wont respond
fixed it myself - plugging in the 3 pin JARGB into the mobo instead of the 4 pin into the NZXT controller fixed the issue
how can we fix this without unplugging the fan because i have problems with my mobo
Hello,
I have the same NZXT F360mm fans plugged into the NZXT CAM controller. I noticed that some LEDs were not functioning as expected. This issue occurs because SignalRGB is only configuring 20 LEDs per channel for the LED strip where the 360mm fans are connected.
To resolve this, you can create a custom fan profile under settings and set the LED strip to 24 LEDs. This should fix the problem
Regards.
1 Like