How to completely disable the built-in fan control?

Support
1

Hey SignalRGB community,

Ever since you forced fan control into the free version, I stopped using it. I’d much rather use my own software than this built-in garbage. Now, whenever I launch SignalRGB, the programs conflict and my 10 fans instantly blast at 100%.

Is there any way to completely disable/kill the fan control in SignalRGB? I want it 100% gone so I can just control my lighting in peace.

Thanks.

2

Thanks for reaching out! New installs ask if you’d like Fan Control enabled, but a re-install may not re-trigger that prompt if it was on before.

Go to Settings > Cooling and Settings > Monitoring to turn off SRGB’s control there. For conflicting apps, add exceptions under Settings > Conflicts so SRGB doesn’t close them.

Hope this helps!

3

Thank you, i try it :+1:

4

Complete opposite for me. My fans are spinning at very high RPM’s until SignalRGB actually starts up. Try to uninstall the software that’s controlling your fan speed. Just a thought if you’re not married to the current fan control software.

5

Usually this is an indicator your BIOS settings or whatever is handling your fan curves when SRGB isn’t in charge are set a bit high.

Might help to double check your BIOS settings for your fans as a start.