I designed and 3D printed a cradle/holder for the Airgoo 16-Port Signal RGB Controller that has restraints for the cable in each channel and a snap-on locking bar for both A and B sides.
Shown in the picture above, the B channels have the locking bar snapped into place while the A channels do not.
If anyone is interested, please let me know.
Hey Jeff,
I was JUST about to start designing this exact thing and thought I’d have a look to see if someone already did it and this is the only one I’ve seen. Can I get the .stl to print it? Or is it posted somewhere? Thanks!
Sent you an email with the .stl shortly after I got the notification. Let me know if you got it ok and how it works out for you. I plan on doing a wee bit of a redesign here shortly. Was going to make the plug retainer fingers part of the locking bar to make it easier to insert into the Airgoo before locking them in place.
Appreciate it! I didn’t receive the email; or at least I can’t find it. Maybe I’m not looking in the right place if you sent it through here. I ended up designing my own, I like the snap on brace you have on yours though…
