I have four fans: two Jonsbo ZB-360BR, a Jonsbo ZB-360B, and a Jonsbo ZB-240B. I added them as custom fans, connecting them to a Nollie 8v2 controller. I discovered that the LEDs are assigned by axis. There’s one LED in the right corner, and the last 68 LED before it. So, when I adjust the backlight, the light doesn’t move from the beginning to the end of the fan, but from the first LED to the last one in a circle. Is it possible to somehow reassign the LEDs?
You could try using the Custom Component Editor the community built at SRGBMods, that might do the trick? Sounds like an issue with how the fans are designed.
I was able to independently divide these fans into LED zones. However, I encountered the following problem: the first 9 LEDs along the axis are detected simultaneously with 27 LEDs on the blades (in the case of the ZB-360V/BR), and the first 9 LEDs along the axis are detected simultaneously with 18 LEDs on the blades (in the case of the ZB-240V).
I found this information on the manufacturer’s website. What could be the problem? Is it a technical feature of the fans themselves, or is the Nollie 8v2 controller failing (the manufacturer’s website states: Single Channel Driver: 126 LEDs)?
The behavior you’re seeing is due to how the RGBs are wired and designed for those fans.